Switch L3/ Router Cisco Catalyst 6506 - SUP720-3BXL

Router show version: 
Cisco IOS Software, s72033_rp Software (s72033_rp-ADVENTERPRISEK9_WAN-M), Version 12.2(33)SXJ1, RELEASE SOFTWARE (fc2)
Copyright (c) 1986-2011 by Cisco Systems, Inc.
Compiled Wed 22-Jun-11 18:03 by prod_rel_team

ROM: System Bootstrap, Version 12.2(17r)SX5, RELEASE SOFTWARE (fc1)

Router uptime: is 6 minutes
Uptime for this control processor is 6 minutes
Time since Router switched to active is 5 minutes
System returned to ROM by reload at 15:00:24 EEST Sat Jan 20 2024 (SP by reload)
System image file is "sup-bootdisk:s72033-adventerprisek9_wan-mz.122-33.SXJ1.bin"

Processor board: ID SAL1133XUXE

Cisco WS-C6506-E (R7000) processor (revision 1.1) with 983008K/65536K bytes of memory.
SR71000 CPU at 600Mhz, Implementation 0x504, Rev 1.2, 512KB L2 Cache
Last reset from s/w reset
1 Virtual Ethernet interface
50 Gigabit Ethernet interfaces
1917K bytes of non-volatile configuration memory.
8192K bytes of packet buffer memory.

65536K bytes of Flash internal SIMM (Sector size 512K).
Configuration register: is 0x2102

Router show platform hardware pfc mode - PFC operating mode: PFC3BXL

Router show platform hardware capacity forwarding 
L2 Forwarding Resources:
MAC Table Usage   Module  Collisions  Total Used  Used %

---------------   ------  ----------  ----------  ------
              5            0       65536         2         1%

VPN CAM usage    Total Used    Used %

-------------    ----------    ------
          512              0          0%
L3 Forwarding Resources:
           FIB TCAM usage           Total     Used   Used %

-------------------------     -------   -----  -------
72 bits (IPv4, MPLS, EoM)     1032192    20       1%
144 bits (IP mcast, IPv6)        8192     8       1%

Detail:

  Protocol   Used    Used %

-----------  ----    ------
IPv4         20        1%
MPLS          0        0%
EoM           0        0%

IPv6          1        1%
IPv4 mcast    4        1%
IPv6 mcast    3        1%

Adjacency usage    Total Used    Used %

---------------    ----------    ------
       1048576            168          1%

Forwarding engine load:
Module   Pps   Peak-pps            Peak-time

------   ---   --------  -----------------------------
     5      8       20      13:19:23 UTC Sat Jan 20 2024

Router show power:
system power redundancy mode = redundant
system power redundancy operationally = non-redundant
system power total =     2771.16 Watts (65.98 Amps @ 42V)
system power used =      1081.08 Watts (25.74 Amps @ 42V)
system power available = 1690.08 Watts (40.24 Amps @ 42V)
                                          Power-Capacity   PS-Fan   Output    Oper
PS      Type         Watts   A @42V   Status   Status   State
-- -------------     -----   ------   ------   ------   -----
1  WS-CAC-3000W     1171.38   27.89     -         -      OFF
2  WS-CAC-3000W     2771.16   65.98     OK        OK      ON

                                                Pwr-Allocated     Oper
Fan       Type          Watts   A @42V   State
---  --------------     -----   ------   -----
  1   WS-C6506-E-FAN     98.70    2.35      OK
                                                     Pwr-Requested    Pwr-Allocated     Admin   Oper
Slot     Card-Type        Watts   A @42V    Watts   A @42V   State   State
----  ----------------   -------  ------   -------  ------   ------  -----
   2    WS-X6748-GE-TX     325.50   7.75     325.50   7.75      ON      ON
   5    WS-SUP720-3BXL     328.44   7.82     328.44   7.82      ON      ON
   6    (Redundant Sup)       -       -      328.44   7.82       -       -

System auxiliary power mode = off
system auxiliary power redundancy operationally = non-redundant
system primary connector power limit = 7266.00 Watts (173.00 Amps @ 42V)
system auxiliary connector power limit = 10500.00 Watts (250.00 Amps @ 42V)
system primary power used = 1081.08 Watts (25.74 Amps @ 42V)
system auxiliary power used = 0 Watt

Router show module:
Mod  Ports                Card Type                       Model         Serial Nr.
---  -----   -------------------------------------   --------------    -----------
 2    48     CEF720 48 port 10/100/1000mb Ethernet   WS-X6748-GE-TX    SAD112300VM
 5     2     Supervisor Engine 720 (Active)          WS-SUP720-3BXL    SAL1128U3CL

Mod          MAC addresses                Hw       Fw             Sw       Status
---  --------------------------------    ----  -----------   ------------  ------
  2   001b.d4ab.655c to 001b.d4ab.658b    2.6   12.2(18r)S1   12.2(33)SXJ1    Ok
  5   0016.c85e.bca0 to 0016.c85e.bca3    5.4    8.5(4)       12.2(33)SXJ1    Ok

Mod         Sub-Module                 Model          Serial      Hw   Status 
--- ---------------------------   --------------   ------------  ----  -------
  2  Centralized Forwarding Card   WS-F6700-CFC     SAL1020NJA1   2.0     Ok
  5  Policy Feature Card 3         WS-F6K-PFC3BXL   SAL1052CHBS   1.8     Ok
  5  MSFC3 Daughterboard           WS-SUP720        SAL1129UXC5   3.0     Ok

Mod   Online Diag Status: 
---   -------------------
  2           Pass
  5           Pass

Log Buffer (8192 bytes):

*Jan 20 13:18:57.791: RP: Currently running ROMMON from F1 region
*Jan 20 13:19:03.939: %SYS-5-CONFIG_I: Configured from memory by console
*Jan 20 13:19:07.291: %SYS-5-RESTART: System restarted --
Cisco IOS Software, s72033_rp Software (s72033_rp-ADVENTERPRISEK9_WAN-M), Version 12.2(33)SXJ1, RELEASE SOFTWARE (fc2)
Copyright (c) 1986-2011 by Cisco Systems, Inc.
Compiled Wed 22-Jun-11 18:03 by prod_rel_team
*Jan 20 13:14:42.671: %SYS-SP-3-LOGGER_FLUSHED: System was paused for 00:00:00 to ensure console debugging output.
*Jan 20 13:18:52.411: SP: SP: Currently running ROMMON from F1 region
*Jan 20 13:19:06.504: %SYS-SP-5-RESTART: System restarted --
Cisco IOS Software, s72033_sp Software (s72033_sp-ADVENTERPRISEK9_WAN-M), Version 12.2(33)SXJ1, RELEASE SOFTWARE (fc2)
Copyright (c) 1986-2011 by Cisco Systems, Inc.
Compiled Wed 22-Jun-11 18:47 by prod_rel_team
*Jan 20 13:19:07.084: %SYS-SP-6-BOOTTIME: Time taken to reboot after reload =  351 seconds
*Jan 20 13:19:07.095: %OIR-SP-6-INSPS: Power supply inserted in slot 1
*Jan 20 13:19:07.243: %OIR-SP-6-INSPS: Power supply inserted in slot 2
*Jan 20 13:19:07.347: %C6KPWR-SP-4-PSOK: power supply 2 turned on.
*Jan 20 13:19:14.175: %FABRIC-SP-5-CLEAR_BLOCK: Clear block option is off for the fabric in slot 5.
*Jan 20 13:19:14.275: %FABRIC-SP-5-FABRIC_MODULE_ACTIVE: The Switch Fabric Module in slot 5 became active.
*Jan 20 13:19:15.611: %DIAG-SP-6-RUN_MINIMUM: Module 5: Running Minimal Diagnostics...
*Jan 20 13:19:23.231: %DIAG-SP-6-DIAG_OK: Module 5: Passed Online Diagnostics
*Jan 20 13:19:24.867: %OIR-SP-6-INSCARD: Card inserted in slot 5, interfaces are now online
*Mar  1 00:00:02.375: DaughterBoard (Centralized Forwarding Card)

Firmware compiled 03-Jun-11 12:45 by integ Build [100]
Jan 20 13:20:05.659: %SYS-CFC2-5-RESTART: System restarted --
Cisco IOS Software, c6lc2 Software (c6lc2-SP-M), Version 12.2(33)SXJ1, RELEASE SOFTWARE (fc2)
Copyright (c) 1986-2011 by Cisco Systems, Inc.
Compiled Wed 22-Jun-11 18:02 by prod_rel_team
Jan 20 13:20:05.663: CFC2: Currently running ROMMON from F1 region